TargetTalk

first of all thanks to let me be a member.
i bought a Matchguns MG2-E rapidfire last week.
i try to shoot it a few rounds "50-100" but realised it was real dirty.
so i took it a part. barrell , grip and upper part " in aluminium"
nothing special there, total of 10 screws.
after that i cleaned and was sure not to touch the electronics..
but after that.. only click click "like when its in safe zone"
i can see the switch/solenoid strikes at the rear but the hammer dont strikes..
ill like to open the rear but cant figure out if i should do that or how ?
any idea ?
Thanks for the help !

since the solenoid works, try and use a fresh battery.

the solenoid strikes and the battery is new.
but i have no idea ow long it should strike..
you have a screw at the rear of the solenoid can you adjust the lenght with that?
anyhow i dont think its that . i try to bypass the solenoid by striking the lever directly with a thin bent rod
but nothing.
what about the cartridge ?
do i need one to do s complete strike ?
i remember it didn need to.

Thanks for the help
/R

i have the mechanical version so i cannot help further. my comment for a fresh battery came from my matchuguns mg1e air pistol experience (electronic trigger).
you could always remove the upper part and try to re install it.

one small spring "behind the hammer" was missing.
so i made one and now it works.."for now " :)