Hi
I have a new to me Pardini SPE with Pardini Fiocchi on the right hand side. Serial number is 4 digits with no prefix.
I am looking to adjust the over-travel and set up the trigger to 1000g for ISSF shooting.
I have seen other information about adjusting the Pardini triggers but none seem to have quite the same layout of screws on the trigger.
Does anyone have an original owners manual out there that they could share.?
I also have a MP in 32 which seems to have a very short recoil spring, shorter than my SPE 22 buy about 15mm, consequently the bolt velocity seems very high and the empties are thrown very violently for quite a distance (4-5 Meters) does anyone know how long a stock recoil spring for a MP 32 should be?
Cheers
Aaron T
New Zealand
1st Generation Pardini SPE 22 & MP 32
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Re: 1st Generation Pardini SPE 22 & MP 32
Hi Aaron,
As for the manuals, go to the pardini website https://pardini.it/en/manuals-and-drawings/ and scroll down to the discontinued items.
On the older models, check if the rubber buffer that the slide bottoms out on is in good order. They eventually crack and need to be replaced.
Hope this helps
As for the manuals, go to the pardini website https://pardini.it/en/manuals-and-drawings/ and scroll down to the discontinued items.
On the older models, check if the rubber buffer that the slide bottoms out on is in good order. They eventually crack and need to be replaced.
Hope this helps