TargetTalk

Hello.
Walther kk500 scope rail? bridge? Can anyone post a picture of what it looks like when you unscrew that part?
And is that part made of aluminum? I want to anodize it in black.

I believe that's made of aluminium. Underneath there's a female 11mm dovetail. The receiver has a matching male dovetail; the rearsight can clamp directly onto the receiver.

Tim S wrote: ↑Fri Apr 25, 2025 4:21 am I believe that's made of aluminium. Underneath there's a female 11mm dovetail. The receiver has a matching male dovetail; the rearsight can clamp directly onto the receiver.

Thank you for your answer.
I'd like to see it in a picture if possible, but there's no place to look, right?

The Blacktec version doesn't have the extended raiser, so you could Google that. It's just an 11mm dovetail, exactly the same as the top of the raiser.

Tim S wrote: ↑Fri Apr 25, 2025 7:06 am The Blacktec version doesn't have the extended raiser, so you could Google that. It's just an 11mm dovetail, exactly the same as the top of the raiser.

Thank you very much.

When you unscrew that little rail section (the “bridge”) on the KK500, it just lifts off and you can see the two screw holes underneath

My KK500 in an Anschutz Precise stock...

1845greyhounds wrote: ↑Sat Apr 26, 2025 4:20 pm My KK500 in an Anschutz Precise stock...

wow thank you

1845greyhounds wrote: ↑Sat Apr 26, 2025 4:20 pm My KK500 in an Anschutz Precise stock...

Is that the bolt release at the back of the dovetail?