Page 1 of 1
Morini 162 Screw Question
Posted: Wed Nov 27, 2024 1:05 pm
by lyoke3
I am looking for the size of the set screws by the trigger blade on the Morini 162EI. See picture below. The front one is for the trigger take up. I am not sure what the back one is for if any one can inform me.
They don't seem to be listed in the exploded views or parts manuals that I have found for the Morini 162.
Any help will be appreciated!
- eT6vKdg.jpg (23.07 KiB) Viewed 1173 times
Re: Morini 162 Screw Question
Posted: Wed Nov 27, 2024 10:00 pm
by NukeMMC
20241127_214810 by
Bruce Cameron, on Flickr
20241127_215005 by
Bruce Cameron, on Flickr
Since it is not listed as an adjustment screw, I would not try and adjust it on my pistol.
Re: Morini 162 Screw Question
Posted: Wed Nov 27, 2024 11:56 pm
by David M
From memory the front screw either a 2.5mm x 0.45 or 3mm x 0.5 grub screw to adjust 1st stage trigger travel.
Maybe 3mm, I think.
The rear hole was originally for a trigger stop screw , but the electronic trigger does not have any trigger
collapse on release. So not required nor fitted as the loads do not change on firing.
Re: Morini 162 Screw Question
Posted: Thu Nov 28, 2024 3:41 pm
by lyoke3
That makes sense! Thank you!