Help removing the regulator of a Morini 162E adapted for interchangeable cylinders
Posted: Sat Aug 31, 2024 2:43 pm
Hi all,
I'm trying to fix a Morini 162E (no I after the E!) that I got recently and has suddenly stopped shooting, although the electronics work and a hard hit is felt.
When I put on a freshly filled cylinder the lever is locked, as if there was no pressure, and when I move it with my finger and cock the gun sometimes there's a very small air release and most of the times none at all.
This has happened suddenly, just after a week when it was shooting fine.
* Any ideas in how to remove the pressure regulator and where to get a new one or fix it?
* Which seals go inside it?
I have not seen Morini seal kits being sold.
Thanks!
I'm trying to fix a Morini 162E (no I after the E!) that I got recently and has suddenly stopped shooting, although the electronics work and a hard hit is felt.
When I put on a freshly filled cylinder the lever is locked, as if there was no pressure, and when I move it with my finger and cock the gun sometimes there's a very small air release and most of the times none at all.
This has happened suddenly, just after a week when it was shooting fine.
* Any ideas in how to remove the pressure regulator and where to get a new one or fix it?
* Which seals go inside it?
I have not seen Morini seal kits being sold.
Thanks!