Page 1 of 1
Match Gun MG5E Scatt mount
Posted: Mon Dec 19, 2022 12:14 pm
by 400driver
Hi,
Is anyone familiar with a mount for the MG5 to fit a SCATT device? I checked on Thingyverse and no returns.
Many thanks
Mark
Re: Match Gun MG5E Scatt mount
Posted: Mon Dec 19, 2022 1:20 pm
by Gwhite
I made some 3D printed blocks for my Morini free pistol a while back. This was for a Noptel trainer, but it should work for a Scatt. I'm not sure if the barrel diameter & taper are the same, but they look close enough.
I've attached a zip file with the two STL files. Due to the taper in the barrel, there is a right & a left side.
Re: Match Gun MG5E Scatt mount
Posted: Mon Dec 19, 2022 5:03 pm
by 400driver
Superb!
Many thanks
Re: Match Gun MG5E Scatt mount
Posted: Mon Dec 19, 2022 6:28 pm
by Gwhite
If the design needs tweaking for the MatchGun, I can export the design as STEP or IGES format CAD files as well.
Re: Match Gun MG5E Scatt mount
Posted: Wed Dec 21, 2022 10:56 am
by 400driver
I will take a look when I have a spare few minutes. I have been using Cura but have very limited experience. Fusion360 is on my learn to do list.
Re: Match Gun MG5E Scatt mount
Posted: Thu Dec 22, 2022 5:45 pm
by mteinum
What's the barrel diameter on MG5? I'm using the
D6-19 clamp on my MU-55
https://www.scatt.com/d6-19-clamp
Re: Match Gun MG5E Scatt mount
Posted: Wed Dec 28, 2022 4:10 pm
by 400driver
am away, will measure on return home.
Re: Match Gun MG5E Scatt mount
Posted: Thu Dec 29, 2022 2:30 pm
by 400driver
its 15.06 mm at a place where you could mount a Scatt unit below. The 3d print will need some rubber slip material to cushion it to fit perfectly. Many thanks G for the files.