TargetTalk

Could someone please let me know what the holes located at the top of the action are for?

The holes that you indicate are in the full length riser, not the action itself. They are threaded for the spacers that are used with the Centra Block Club risers https://shop.mec-shot.com/sights/sight- ... -club.html

Hmm, this question made me think. I've seen photos of a couple of KK500s, notably Franziska Peer and Sergey Kamenskiy, which have vertical grooves on the front right sight of the receiver, where the barrel tenon is held. I can't think what these are for. The barrel is glued into the receiver AFAIK, and splits in this plane wouldn't provide any clamping force like the Anschutz 2013 or early KK200s. Any thoughts?

Does this help?

Must say,

Would love to see more pictures of that wood stock.

Thanks,
Jay

jhodge wrote: ↑Sun Jan 10, 2021 9:03 am Does this help?

Sorry, I can't open that file.

jhodge wrote: ↑Sun Jan 10, 2021 9:14 am Must say,

Would love to see more pictures of that wood stock.

Thanks,
Jay

More here on the maker's website:https://doantrevor.com

Figured that might be his work.

Jay

Does this pic help explain the OP's question?

Tim S,

If you still can't open this file, its nothing but a pic of a stock KK500 with the sights mounted so the OP can see what the holes are for.

Jay

jhodge wrote: ↑Sun Jan 10, 2021 10:19 pm Does this pic help explain the OP's question?

Tim S,

If you still can't open this file, its nothing but a pic of a stock KK500 with the sights mounted so the OP can see what the holes are for.

Jay

That photo has an additional raiser block on-top which still doesn't demonstrate what the holes are for.

GolfShot wrote: ↑Mon Jan 11, 2021 12:11 am That photo has an additional raiser block on-top which still doesn't demonstrate what the holes are for.

What he means is that the holes in the full length riser turn it into the bottom half of a Centra Block Club. See here:https://www.intershoot.co.uk/acatalog/C ... s-255.html

Screw the little spacers into the holes then screw the top dovetail from a Block club in top. You could have finer adjustment than just sliding another riser onto the full length one.

jhodge wrote: ↑Sun Jan 10, 2021 10:19 pm Does this pic help explain the OP's question?

Tim S,

If you still can't open this file, its nothing but a pic of a stock KK500 with the sights mounted so the OP can see what the holes are for.

Jay

Gotcha, I thought it might have been in response to my subsequent question.

thank you for all your responses