Page 1 of 1
Grooved rifle receivers... 3/8" vs. 11mm question
Posted: Thu Aug 31, 2017 7:01 am
by 218bee
Looking at a clamp-on Skinner receiver peep sight billed as being for an "11mm CZ 452/455 receiver". Will this same sight fit grooved 3/8" US models like the Winchester 69A, 72, 9422, etc...?
Thanks for any help here..
Re: Grooved rifle receivers... 3/8" vs. 11mm question
Posted: Thu Aug 31, 2017 10:58 am
by j danielsson
1 inch equals 25.4 millimeters.
Re: Grooved rifle receivers... 3/8" vs. 11mm question
Posted: Thu Aug 31, 2017 8:41 pm
by Black_Talon
218bee wrote:Will this same sight fit grooved 3/8" US models like the Winchester 69A, 72, 9422, etc...?
Thanks for any help here..
No it will not. An 11mm dovetail is different than a 3/8" dovetail. You will have to find a sight made for a 3/8" dovetail if you want to mount it on a 3/8" dovetail.
Re: Grooved rifle receivers... 3/8" vs. 11mm question
Posted: Fri Sep 01, 2017 1:33 pm
by j danielsson
11mm is very near 7/16". Should have said that yesterday but my brain refused to function.
Re: Grooved rifle receivers... 3/8" vs. 11mm question
Posted: Fri Sep 01, 2017 8:53 pm
by 218bee
Thanks guys....I appreciate it..