TargetTalk

I am trying to mount an Ultradot on this gun. Have to remove rear sight.
It is dovetailed into the slide and also pinned. The pin is a roll pin that goes into a blind hole in the slide. The hole does pop through the inside of the slide but only a portion of its diameter is seem. No way to get a punch in there. I see no way of removing this pin. Does any one have experience removing rear sights form Hi-Standards. This rear is mounted on the slide, not on the bridge like the later HS's.

Help,
Dr. Lee

If you don't get an answer here, give High Standard a call in Texas. Ask for Tech Support.

I figured it out. Got the Ultradot mounted, sighted it in. Its now ready the some matches.

I don't know if you have ever dealt with HS, but I have and so have countless other shooters. WORST SERVICE EVER !!!

We should all chip in and buy this company to save it for the good of the shooting community.

I will never call them for anything again.

Thanks for the reply, though.

Dr.