Page 1 of 1
Montana Gold bullets
Posted: Sat Aug 11, 2012 10:49 pm
by tleddy
Does anyone have experience with them?
Especially the 185 gr JHP...
Montana Gold Bullets...
Posted: Sun Aug 12, 2012 4:13 am
by GOVTMODEL
...are fine. The jacket material is different from most, so make sure your barrel is free of jacket fouling before you shoot them.
Posted: Sat Aug 25, 2012 11:53 am
by Chris
buy some testing them using a ransom rest and see if they work for you. They did not test good in my barrel. I got better results from the 185gr SWHP from Zero. 1.8" at 50 yds.
You have to test to figure out what works for you. I tested about 40 different loads. 5 powders, 3 or 4 different bullets and for each one I think I had 3 different loads. It has been a while.
example:
bullet A Powder A 3.8gr (load 5 rnds)
bullet A Powder A 4.0gr (load 5 rnds)
bullet A Powder A 4.2gr (load 5 rnds)
bullet A Powder B 3.8gr (load 5 rnds)
bullet A Powder B 4.0gr (load 5 rnds)
bullet A Powder B 4.2gr (load 5 rnds)
If Powder A and B are similar enough you can use the same load but for others you need to adjust it up or down so your slide will function and it may take some experimenting to find the correct load to get a good group. There was one powder i should have loaded hotter and one I should have loaded lighter. Since I found 3 loads around 1.8" I decided I got what I needed and would use those loads for matches on the long line.