Page 1 of 1
Doubt with Steyr LP2 barrel weight mounting
Posted: Wed Jul 04, 2012 3:18 am
by narayanan
Normally with every barrel weight a screw goes through the barrel weight & tightens up against the barrel. But with the the 25g barrel weight of the LP2, The screw doesn't come into contact with the barrel at all. So how is this barrel weight able to stay in a constant position and not fall off ? Could some one please clear my doubt with a detailed explanation ?
Posted: Wed Jul 04, 2012 5:01 am
by taz
It looks like the screw pushes on the other side of the barrel weight essentially bending the thin part in the middle so the lower part of the weight clamps the barrel.
I hope this makes sense.
Posted: Wed Jul 04, 2012 6:23 am
by RobinC
Taz is spot on, the screw flexes the weight so it pinches onto the barrel, it works well and is no problem.
Good Shooting
Robin
Posted: Wed Jul 04, 2012 6:23 am
by RobStubbs
taz wrote:It looks like the screw pushes on the other side of the barrel weight essentially bending the thin part in the middle so the lower part of the weight clamps the barrel.
I hope this makes sense.
I think that's exactly right. It certainly works fine and clamps securely as my wife has the LP2 and if I shoot it I add the weight on.
Rob.
Lp2 barrel weight mounting
Posted: Wed Jul 04, 2012 8:05 am
by narayanan
Thank you all for clearing my doubt. Can this be used on Morini air pistols like the CM 162EI & MI.
Posted: Wed Jul 04, 2012 9:39 am
by Gwhite
It would only work if the barrel diameters are extremely close to the same. The odds of that are a bit limited, but it's possible.
Posted: Thu Jul 05, 2012 1:48 am
by RobStubbs
Gwhite wrote:It would only work if the barrel diameters are extremely close to the same. The odds of that are a bit limited, but it's possible.
Whether or not the theoretical chances are limited, it works in practice.
Can this be used on Morini air pistols like the CM 162EI & MI.
I'm pretty certain barrel dimensions are different so almost certainly not.
Rob.
Doubt with Steyr LP2 barrel weight mounting
Posted: Thu Jul 05, 2012 2:03 am
by narayanan
Has any one ever tried mounting the 25 g weight of the lp2 to the Morini Cm 162EI or MI ?
Posted: Thu Jul 05, 2012 5:41 am
by Tycho
Nope, seems to be your chance to be first.
Posted: Thu Jul 05, 2012 2:38 pm
by Richard H
The barrels aren't vastly different in size, if the weight is too small to fit on the 162 barrel just file some out, if the weight is too big to fit tightly use some shim material.
If your interested in trying it you should get one, I really think it could be made to work.
That said if you have some rudimentary tools you could probably make one out fo bar stock. You'd need a drill press, a drill slightly bigger that your barrel, a small drill, a tap, a set screw and a saw (hacksaw would even work) to put groove in. Then you could make them any weight you wanted.