the manual is very vague regarding this, I would like to drop my wrist more than is allowed at the moment, all it says in manual is adjust screws 1 and 2. screw 2 turns quite easily but i left as is, screw 2 seems to be a large torx head screw on and appears to be perhaps what i want it looks like it is holding the sledge type arrangement that if i could slide it up may achieve my purpose. But would like to know if this is the case before i get the screwdriver on it and springs burst out everywhere. Hope someone knows.
Thanks for any help on this
Morini cm162mi grip adjustment
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Morini cm162mi grip adjustment
ok looked at it with fresh eyes this morning and my problem was i take things too literally, screw 2 changes the rake if that is the right word, raises the action so i am not shooting straight wristed, screw 1 is what confused me cause i was looking for 1 screw, and it is the 2 screws to change the angle left or right. apologies for being a dumbass