Page 1 of 1
walther cp3 o-rings neede
Posted: Fri Jul 15, 2011 3:11 am
by gfrad
does anyone know the correct measurements for replacement seals for wp3 co2 pistol i believe the measurements are O-Ring ø14,0x3mm ,O-Ring ø6,0x2 ,O-Ring ø15,0x2 ,O-Ring ø4,0x1 ,O-Ring ø9,0x1,5
but I also need Inner Diameter:
and Width:
Posted: Thu Jul 21, 2011 9:14 pm
by Raymac
Valve seal..........PN 249 00 21........6.0 X 2...green
Bolt seal.................247 23 09........4.0 X 1...black
Barrel seal..............247 22 95........9.0 X 1.5...black
Cylinder seal...........245 98 17......14.0 X 3...green
Cylinder fitting.........247 62 66......15.0 X 2...black
Two of the o-rings must be the green material that is compatible with CO2....black will not do. The inner diameter can be calculated if you need to.
cp3 o-rings
Posted: Mon Jul 25, 2011 3:56 am
by gfrad
would you know were I can buy them from also an o-ring company i contacted is asking for width along with inner diameter
Posted: Mon Jul 25, 2011 11:53 am
by Raymac
Order from Earl's Repair using the Walther part numbers
http://www.carlwalther.com/
cp3 orings
Posted: Tue Jul 26, 2011 5:09 am
by gfrad
at $5.00 an oring thats expensive anywere else from oring storethat i can find for better price
Really?
Posted: Tue Jul 26, 2011 10:34 pm
by headwizard
Most specialty companies have a minimum order amount. The difference in that amount and the $30 you'll spend for the CORRECT o-rings will probably be negligible.