Where can I get a seal kit for a Walther CP2?

deadin · Post by **deadin** » Sun May 01, 2011 6:00 pm

My CP2 has a slow leak and I assume it is in the valve seal as the cylinders will hold pressure as long as they are not mounted. The leak doesn't seem to affect the use of the gun except it will drain the cylinder over time. I also need instructions showing how to get at and replace the seals.

Thanks,
Dean

(Please pardon me if this is a duplicate post. My first attempt seems to have disappeared.)

Greg Derr · Post by **Greg Derr** » Sun May 01, 2011 6:03 pm

Champions Choice or our host Pilkguns may have them.

Raymac · Post by **Raymac** » Mon May 02, 2011 9:06 pm

The factory part numbers that you will need for CP2 pistols with serial No after #7501 are;
O-ring 12 X 2 #243 79 02
spring #247 07 13
valve #247 55 37
o-ring #245 96 47
These are for CP2 pistols. CP2 MATCH models and CP2 pistols having a serial no. before#7500 require different part numbers.
You may only require the o-rings if the other parts are in good shape.
Earl's Repair in the USA will probably have them in stock.
If you send me your e-mail address I will send you the complete installation instructions.
Ray
mcdougall.imports@shaw.ca

deadin · Post by **deadin** » Tue May 03, 2011 8:58 am

Ray,
Thanks for the info. I found the seals at pilkguns, but I could use the instructions. (Especially how to get the bolt out to replace the chamber seal....) My gun is a CP2 MATCH,

Dean
deadin@att.net

Raymac · Post by **Raymac** » Tue May 03, 2011 11:54 am

Valve parts for the CP MATCH are;
O-ring 15 X 2 #247 62 66
spring #247 07 13
valve #247 64 01
o-ring #249 00 21
bolt o-ring #247 23 09
I have sent the instructions to you by e-mail.

Ray

deadin · Post by **deadin** » Tue May 03, 2011 8:01 pm

Ray,
Got them!!

Thanks,

Dean