TargetTalk

Just purchased 1000 new .32 Hertenberger brass cases. Has anyone had any big issues using dillon press and dies to load wadcutters. I've never used these before, always Lapua or winchester. Just wondering if the wall dimensions are the same as other brass or are they going to be tight in the dies. Any comments or experiences would be appreciated. Will be loading for new pardini .32.

I have a bunch and have never had any issues. I use a Dillion 550.

I'm shooting a mix of Lapua, Hirtenberger (that's the right spelling, btw) and Geco, no problems at all. The Hirtenberger cases have a pretty sharp angle around the primer pocket, I crunch up slightly more primers on them than on the other ones, but that's not really an issue.