Page 1 of 1
MG1/GP1 grip adjustment
Posted: Wed May 20, 2009 3:42 pm
by Guest
The manual says to turn the screw on the right side of the frame to vary the angle side-to-side. It doesn't mention the corresponding screw on the left side. Doesn't that have to be turned also?
Posted: Wed May 20, 2009 11:24 pm
by dhurt
i think the two sides are connected, when you screw one side in, it moves out on the other. This keeps the adjustment centered in the grip. Dwaine
Posted: Thu May 21, 2009 10:40 am
by Guest
dhurt wrote:i think the two sides are connected, when you screw one side in, it moves out on the other. This keeps the adjustment centered in the grip. Dwaine
Dwaine,
Thanks. That makes sense and explains why only one side is addressed in the manual.
Posted: Thu May 21, 2009 4:23 pm
by luftskytter
That seems to be correct: long time since I adjusted mine, but looking at it only the right hand screw head has a hex hole in it. The left is just flat.
So it can only be adjusted from the right hand side.