TargetTalk

I have a Pardini K60 and received a seal kit from Larry's Guns. In the kit there are 8 o-ring type seals. 3 seals go into each CO2 cylinder of which I have two cylinders. That leaves 2 seals left over. The brown color wide seal goes onto chambering cone slide. That leaves 1 seal left over. This is a small 0-ring that is clear in color, just like the 2 clear color o-rings that go into the cylinder, however this 0-ring is smaller in size, just larger than the little very small o-ring that goes in the cylinder. I have the K60 schematic and I still can't figure where that last o-ring goes.

Where does the left over fairly small clear color o-ring go. It has to go in the receiver someplace or is this just an oddball o-ring that got packaged in error? dave