Page 1 of 1
FWB C60 CO2 seal problem....
Posted: Sun Apr 27, 2008 7:58 pm
by reaboy
I filled my two CO2 tubes yesterday and when installing the first one, gas started to escape as I finished tightening it and then it was escaping out of the open breech.......
Did I blow a seal??? Who can I send this to for repair or is it easy to do for a competent DIY'er?
Thanks
Todd
Posted: Mon Apr 28, 2008 1:35 am
by azuaro
Dear Todd,
This is a normal problem after the wear of time...
Get the original FWB seals from Nikkonos in Canada, I have done several of my CO2 old guns and have purchased the seals and accesories from him...HIGHLY RECOMMENDED, Nick is a nice person to deal with...
The kit for your C60 (all seals for gun and CO2 cylinders) costs $34.00 Canadian Dollars (cheap) and you can replace them yourself, the kit comes with a diagram...
Just make sure that you do not use any petroleum based lubricant as this will destroy the seals - o-rings.
Go to:
http://cgi.ebay.com/Feinwerkbau-Beeman- ... dZViewItem
Best regards,
AZUARO
Flathead Lake, MT
C60 seals
Posted: Mon Apr 28, 2008 7:29 am
by reaboy
Perfecct.....
Thanks much
Todd
C60 seals
Posted: Mon Apr 28, 2008 7:30 am
by reaboy
Perfecct.....
Thanks much
Todd