TargetTalk

I have a question about what to use behind a 10M air rifle stand to stop pellets.

Go to this link for two types of stands:
http://www.odcmp.com/Coaching/target_stand_plans.htm

I prefer the Lujan type of stand as I can have my shooters setup a full set of 3x20 targets and not have to change the backstop position after each position.
If you build these in sets of 4 they will run about $50-60 apiece to construct

If it is for personal use check out the Targetworx traps ... the target rolls are more expensive than the AR 5/10's though. (a google search will find them)

Ours are built for 3P

The back board is 1/2 plywood but we mounted 14 Ga steel sheet to it.

We oil it every now and then to keep the rust down and it helps kep the pellets sliding off of it after they flatten.