Me too - I need new seals for my 1.77 LGR, i need the knock valve seal or spring as when I push lever fwd it blows air down barrel.
Does any body know where I can buy seals? I can fit.
Cheers & good shooting Itchy
Walther LGR information/questions...
Moderators: pilkguns, Marcus, m1963, David Levene, Spencer
-
Greg Hornbostel
- Posts: 1
- Joined: Sun Nov 18, 2007 9:15 am
LGR seals
Lewis Reinhold has new piston seals lewisbelinda@yahoo.com $AUS30 plus $AUS 10 shipping. In an act of desperation I disassembled my LGR and put the piston in my lathe. Using a lmm wide parting tool I cut a 2mm deep groove in the face of the piston seal 2mm from the outside diameter. That was 1500 pellets ago and it still cuts clean holes at 10m. I have decided to leave it like this until it no longer cuts clean holes. Be very careful when you put the piston back into the cylinder as the seal edge catches very easily. Lots of Luck
Greg Hornbostel
Greg Hornbostel
-
Robin C
LGR spares
Walther Supplies of Worthing, England has spares in stock, phone Bill Welch on 01903 - 246301
Regards
Robin
Regards
Robin