New Morini 162EI - Hooray!

If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true

Moderators: pilkguns, m1963, David Levene, Spencer, Richard H

Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Post Reply
K38
Posts: 186
Joined: Sat May 28, 2005 2:18 pm
Location: Buda, TX

New Morini 162EI - Hooray!

Post by K38 »

I just received my new Morini162 EI today. I purchased it from our host and it is a very nice piece of work. I also got a Hill pump, that thing is built like a tank! They have improved the way the foot fastens to the pump — no more screws just a single screw on cap. It is a bit of a work out to pump up the cylinder from dead empty, but not too bad. The 162EI is very nicely finished and the trigger is a dream, very easy to adjust. About the only thing I would take issue with is the plastic (Carbon Fiber?) trigger guard, it seems a bid flimsy for such a high quality pistol. The XL Morini Grips fit my big mitt perfectly I doubt I will have to do a thing to them. Now all I need to do is get back to practicing!!!

Happy Days!

Dwight
Top
User avatar
Tim_T
Posts: 13
Joined: Wed Mar 03, 2004 7:38 am
Location: Queensland, Australia
Contact:
Contact Tim_T

Post by Tim_T »

Dwight, one thing i have done to improve the trigger on my 162 is to add an additional grub screw in the rear of the trigger block to remove a lot of the after travel of the trigger. I personally don't like a lot of after travel on my triggers.

Regards

Tim
Top
Post Reply

Return to “Olympic Pistol”