I purchased this gun at the end of february and I'm very satisfied with it
Let's start by picking the gun in the wallet, just after a session at the range
(One can notice that my Hammerli AP40 hast just been equiped with a Rink grip...)
![Image](http://olivierthomas14.free.fr/TIR/SSP/Pistolets.jpg)
Ready to go !
![Image](http://olivierthomas14.free.fr/TIR/SSP/D%E9part.jpg)
Slide locked in rear position
I'm removing the cover screws of damping system and striker system :
Here are the disassembled cover screws (left : the one with the 0.6 mm nozzle, right : the 1 mm nozzle screw) :
And now removing the frame main fixing screw :
![Image](http://olivierthomas14.free.fr/TIR/SSP/Vis.jpg)
Let's install the stripping tool (will help to lock the slide in rear position and to keep the striker and damper springs in place) :
Splitting !
Here is the upper part of the gun : The barrel is surrounded by the striker and damper rods (the rods are located on both sides of the barrel Walther's logo) :
I unlock the slide mechanism, it slightly moves toward the muzzle of the gun and I can now disassemble it from the rods :
Finally I remove the striker from the mechanism : piece of cake
Here's the grip with the trigger system :
![Image](http://olivierthomas14.free.fr/TIR/SSP/Bloc%20d%E9tente.jpg)
Ok after a good cleaning and lubrication (ballistol), let's rebuild this baby.
Nearly done ! :
End of task :
The whole operation took 12 minutes (without disassembling the trigger mechanism) and is very easy to do.
I apologize for my english which is not my native language (I'm french, nobody's perfect...)
If you've any question, I will happily reply