Trigger adjustment on p240
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
-
Ray Garrett
- Posts: 1
- Joined: Sat Apr 23, 2005 8:34 pm
- Location: Griffin, Ga.
Trigger adjustment on p240
("please") Just obtained a P240 (32) and get "doubling", caused by ?(trigger pull too light?) and need to know which screw to adjust to cure trouble. I printed-out instruction sheet, just need to know WHICH screw to adjust. ("thanx!"), Ray
-
Mike Taylor
- Posts: 212
- Joined: Mon Mar 01, 2004 4:03 pm
- Location: Okanagan Valley, British Columbia
Adjusting trigger
Since you are getting doubling, I would suspect the hammer/sear engagement adjustment-screw is the one. However, I note in the manual that screw B is "principally only for adjustment at the factory" and screw C "must not be touched", so if a previous owner of the gun played with either or both of those screws, you may need the help of someone more experienced than I. Perhaps a call to Larry Carter is in order? I understand that he is very helpful regarding Hammerli problems.