Morini CM84E trigger travel adjustment?

If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true

Moderators: pilkguns, m1963, David Levene, Spencer, Richard H

Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Post Reply
Anders Turebrand
Posts: 82
Joined: Fri Mar 26, 2004 6:27 pm
Location: Stockholm Sweden

Post by Anders Turebrand »

I´ve heard of someone who made the triggerblade springloaded with about a mm travel.
I believe he used two screws, one close to the bend on the trigger blade with a small spring holding the blade down (really up...) onto the trigger lever and one on the front of the trigger blade adjusted to let the trigger blade move that 1 mm, both screws set with loc-tite.
He might have made his own blade with holes instead of the original slot...


From what a have seen (on mine), one half of the trigger switch is fixed to the trigger lever, making adjustments to pre-shot travel impossible.

/Anders
Anders Turebrand
Posts: 82
Joined: Fri Mar 26, 2004 6:27 pm
Location: Stockholm Sweden

Post by Anders Turebrand »

I haven´t fiddled too much with the trigger on mine except for the position of the blade, the weight on mine is about 20 grams.

Perhaps if you increase the weight it will feel as though there is some pretravel (compression of finger pad, flex in the trigger blade...) but I´m not sure.

/Anders
Post Reply