Compensator For Walther CP2

[Matt]

Is there a compensator made for the Walther CP2? And if there is, who makes/sells them?

[shotman]

Matt,

If I were you, I would have a look at the Nygord's website. They manufacture and sell compensators for most of the airguns in the market.
Type Nygord in the search box of Google, and you will find a lot of links to the website.
Best regards

[Richard Newman]

I contacted Don Nygord a year or so ago about a compensator for my CP2. Unfortunately, the configuration of the CP2 in which the CO2 cyllinder and the front sight both extend to the front of the barrel, with only a very small clearance was a problem, and Nygord didn't think that the compensator would fit properly. I haven't found any other that will fit the CP2, and I sure can use any help I can get!!!!
Richard Newman

[Charles]

I contacted Don Nygord a year or so ago about a compensator for my CP2. Unfortunately, the configuration of the CP2 in which the CO2 cyllinder and the front sight both extend to the front of the barrel, with only a very small clearance was a problem, and Nygord didn't think that the compensator would fit properly. I haven't found any other that will fit the CP2, and I sure can use any help I can get!!!!
Richard Newman

In stock form that is correct. But I milled a shallow lenghtwise slot on the bottom of my Nygord Turbo Comp and it fits perfectly on my CP2 and allows clearance to screw the CO2 cylinder on with no problems.

Charles

[rogerv]

I bought a CP2 Match with a Nygord Turbocomp already mounted. After reading your post I checked it out and found the paint worn off the bottom of the comp. I took a Dremel and ground the soft aluminum until the barrel floated freely. I then had to add 12 clicks of elevation to rezero. Group sizes (from a vise) did not change.

[Guest]

I contacted Don Nygord a year or so ago about a compensator for my CP2. Unfortunately, the configuration of the CP2 in which the CO2 cyllinder and the front sight both extend to the front of the barrel, with only a very small clearance was a problem, and Nygord didn't think that the compensator would fit properly. I haven't found any other that will fit the CP2, and I sure can use any help I can get!!!!
Richard Newman

I ordered a compensator for the CP2 (from Nygord) that was supposed to fit (and they even included another type just in case). However, I returned both because neither one had the proper i.d. to receive the barrel properly. Too bad, I thought they were the manufacturers.

Does anybody have any other ideas as far as sources/manufacturers to contact?

[Guest]

In stock form that is correct. But I milled a shallow lenghtwise slot on the bottom of my Nygord Turbo Comp and it fits perfectly on my CP2 and allows clearance to screw the CO2 cylinder on with no problems.

Charles

Here is a photo of the Nygord Turbo comp modifications for the CP2

For reference, my barrel diameter is 0.470"

Charles

http://members.cox.net/crmeyer/turbocomp.jpg