10 M aiming ethics

If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true

Moderators: pilkguns, m1963, David Levene, Spencer, Richard H

Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Post Reply
400driver
Posts: 126
Joined: Tue Aug 21, 2012 7:15 am
Location: Barcelona , Spain

10 M aiming ethics

Post by 400driver »

A few of my friends are using the lower horizontal edge of the 10M pistol target to align their sights for the shot. I tried this yesterday and was quite surprised with the good group it produced ! It just felt a bit like cheating in my mind. All my books suggest a sub six hold , not a sub zero one.

Is this done by anyone else? Your thoughts? Is it a temporary bump in skill that is worth pursuing. You still need to work on the left /right alignment but the vertical is taken care of with this method.
Thanks
Mark
Coolmeester
Posts: 128
Joined: Mon Apr 04, 2016 1:35 pm
Location: Finland

Re: 10 M aiming ethics

Post by Coolmeester »

My opinion:

Shooting to lower edge takes focus away from the sights. AP shooting is 95% aligning only the front and the rear sight and pulling the trigger. The front sight doesn't have to be on the exact aiming point on the target to get ten.
Center-fire pistol
Standard pistol
Rapid fire pistol
Free pistol
Air pistol
Gwhite
Posts: 3444
Joined: Sat Sep 04, 2004 6:04 pm
Location: Massachusetts

Re: 10 M aiming ethics

Post by Gwhite »

Many times when you make a change like this, you will see a momentary improvement because it forces you to concentrate on the fundamentals while you get used to doing something different.

The reason a 6:00 hold isn't recommended is that it increases the tendency to look at the target and not the sights. Holding at the bottom of the paper will have the same issue. A sub-6 hold is often referred to as an "area hold", because you are not trying to aim at a precise spot on the target. It helps you to accept your hold (however good or poor it may be), and to focus on sight alignment and trigger squeeze, which is where all the 10's are hiding...
400driver
Posts: 126
Joined: Tue Aug 21, 2012 7:15 am
Location: Barcelona , Spain

Re: 10 M aiming ethics

Post by 400driver »

Great explanations.
Thanks
thirdwheel
Posts: 205
Joined: Sat Feb 08, 2014 2:16 pm
Location: England

Re: 10 M aiming ethics

Post by thirdwheel »

"where all the tens are hiding"

Brilliant!
seamaster
Posts: 645
Joined: Sun Jan 16, 2011 6:24 pm

Re: 10 M aiming ethics

Post by seamaster »

As long as you have a space between you front sight and target, you might think you are @ 6, in reality, you are still sub-6.

True @6 o'clock hold, your front sight would be merging into target.

You are still sub-6, albeit a very high, fine sub-6. But you are still sub-6.

A high sub-6 is where most tens are hiding.
Gwhite
Posts: 3444
Joined: Sat Sep 04, 2004 6:04 pm
Location: Massachusetts

Re: 10 M aiming ethics

Post by Gwhite »

400driver
Posts: 126
Joined: Tue Aug 21, 2012 7:15 am
Location: Barcelona , Spain

Re: 10 M aiming ethics

Post by 400driver »

I am definitely sub sub 6! My best shots have come from about the 3 ring. Good link to the sight picture thread, I have read it before and was a good refresh.
jenrick
Posts: 158
Joined: Fri Sep 25, 2009 2:16 am
Location: Central Texas

Re: 10 M aiming ethics

Post by jenrick »

I've used a proportional hold (the post that's linked just a few above this one), in free pistol for while with moderate success. I do find if more sensitive to lighting than some of the other options. Changes in the direction of the light can make the gap between the base of the target and the top of the front sight appear smaller or larger, causing vertical changes. If you are a hard holder this is less of an issues, and you can correct for it during your sighters without too much difficulty.
Post Reply