A Difficult Lesson in Simple Gun Safety
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
- SlartyBartFast
- Posts: 579
- Joined: Fri Jun 10, 2016 11:04 am
- Location: Montreal, Québec, Canada
A Difficult Lesson in Simple Gun Safety
- Smith & Wesson SW22 Victory
- FAS SP607
- FAS SP607
Re: A Difficult Lesson in Simple Gun Safety
I learned a long time ago there is no such thing as an accidental discharge, only negligent discharges.
Or is this a case of the only thing to stop a bad dog with a gun would be a good dog with a gun?
Or is this a case of the only thing to stop a bad dog with a gun would be a good dog with a gun?
Re: A Difficult Lesson in Simple Gun Safety
Negligent discharges and legitimate mechanical failures.william wrote:I learned a long time ago there is no such thing as an accidental discharge, only negligent discharges.
However, any harm from the latter are mitigated by non-negligent handling practices. Case in point, I've had an old Martini-action BSA go off in my hand - the striker went forward as soon as the block was raised into position due to a worn trigger sear. No, I did not accidentally catch the trigger with a finger - we were able to reproduce the fault. However, no harm came of the fault because the rifle was pointed in a safe direction at the target when I closed the action. Not pointed at my stomach...).
Re: A Difficult Lesson in Simple Gun Safety
I'd say >90% of "accidental" discharges are negligent. I had a 1911 go full auto when the sear broke on my 1st shot with a full mag, pretty intense pucker factor, good thing I had a good grip on it.william wrote:I learned a long time ago there is no such thing as an accidental discharge, only negligent discharges.
- Dave
Certified Safety Instructor: Rifle & Pistol
They that give up essential liberty to obtain a little temporary safety deserve neither liberty nor safety.
~ Ben Franklin
They that give up essential liberty to obtain a little temporary safety deserve neither liberty nor safety.
~ Ben Franklin
Re: A Difficult Lesson in Simple Gun Safety
I don't want to put too fine a point on it, but....
"I've had an old Martini-action BSA go off in my hand - the striker went forward as soon as the block was raised into position due to a worn trigger sear." Is it not a basic gun-handling safety procedure to have an old gun inspected by a competent gunsmith before use?
"I've had an old Martini-action BSA go off in my hand - the striker went forward as soon as the block was raised into position due to a worn trigger sear." Is it not a basic gun-handling safety procedure to have an old gun inspected by a competent gunsmith before use?
-
- Posts: 857
- Joined: Fri Mar 10, 2017 7:34 am
- Location: Copperhill Tennessee USA (a registered CERCLA superfund site)
Re: A Difficult Lesson in Simple Gun Safety
. . . .
Last edited by atomicgale on Thu Feb 01, 2018 1:15 pm, edited 1 time in total.
Re: A Difficult Lesson in Simple Gun Safety
Talking about simple gun safety: A friend and I were at the local indoor pistol range. He wanted to shoot my S&W 38 hammerless snub nose, so I put 5 rounds in it and gave it to him. this pistol has a long trigger pull which he wasn't use to and after trying twice to get the round to go off, he points the loaded pistol at his head while pulling the trigger to see if he can find out "what's wrong with this damn thing, it won't shoot." Thank God he didn't blow his damn head off. And, by the way, you would not believe what his shooting credentials were !! Really frightening.
Hammer to shape, file to fit, paint to match...
Re: A Difficult Lesson in Simple Gun Safety
BSA Martinis aren't so old that you should expect major parts failures during regulag use. It's more likely that the trigger was fettled by an amateur gunsmith in an attempt to lower the weight below the design limits. I've come across a few BSAs "improved" in this way, and the sear will mostly hold, but work the lever a little too fast, or find a cartridge that's a little longer/fatter/waxier and it will give way as you close the breech.william wrote:I don't want to put too fine a point on it, but....
"I've had an old Martini-action BSA go off in my hand - the striker went forward as soon as the block was raised into position due to a worn trigger sear." Is it not a basic gun-handling safety procedure to have an old gun inspected by a competent gunsmith before use?
Mechanical faults can also develop slowly, such that there is no warning a gunsmith is needed until BOOM.
Re: A Difficult Lesson in Simple Gun Safety
Is this meant to be funny?atomicgale wrote:"Hemmer" is from the UK - what else would you expect from a Wanker? ABSOLUTELY NEGLIGENT. But the Limeys only make excuses for their ineptitude . . . .
-
- Posts: 857
- Joined: Fri Mar 10, 2017 7:34 am
- Location: Copperhill Tennessee USA (a registered CERCLA superfund site)
Re: A Difficult Lesson in Simple Gun Safety
!!!
Last edited by atomicgale on Thu Feb 01, 2018 1:16 pm, edited 1 time in total.
Re: A Difficult Lesson in Simple Gun Safety
Tim, ignore him if you can. Tennessee is our version of Cornwall but without the history, beautiful coastline, scrumpy, excellent bitter by the pint, and the 'quaint' tradition of marrying people who don't already have your last name.Tim S wrote:Is this meant to be funny?atomicgale wrote:"Hemmer" is from the UK - what else would you expect from a Wanker? ABSOLUTELY NEGLIGENT. But the Limeys only make excuses for their ineptitude . . . .
-
- Posts: 857
- Joined: Fri Mar 10, 2017 7:34 am
- Location: Copperhill Tennessee USA (a registered CERCLA superfund site)
Re: A Difficult Lesson in Simple Gun Safety
...
Last edited by atomicgale on Thu Feb 01, 2018 1:16 pm, edited 1 time in total.
-
- Posts: 857
- Joined: Fri Mar 10, 2017 7:34 am
- Location: Copperhill Tennessee USA (a registered CERCLA superfund site)
Re: A Difficult Lesson in Simple Gun Safety
.
Last edited by atomicgale on Thu Feb 01, 2018 1:17 pm, edited 1 time in total.
Re: A Difficult Lesson in Simple Gun Safety
Accidents can be minimized but not always eliminated. I am thankful to have had good luck in a couple! I also prefer to remain nonjudgemental and friendly to all our friends.
Re: A Difficult Lesson in Simple Gun Safety
I once had a heated discussion in a pub with a chap from Tennessee who was convinced his state had an Atlantic coastline. I'll guess it was a relative of Atomicgale.william wrote: Tim, ignore him if you can. Tennessee is our version of Cornwall but without the history, beautiful coastline, scrumpy, excellent bitter by the pint, and the 'quaint' tradition of marrying people who don't already have your last name.
-
- Posts: 857
- Joined: Fri Mar 10, 2017 7:34 am
- Location: Copperhill Tennessee USA (a registered CERCLA superfund site)
Re: A Difficult Lesson in Simple Gun Safety
.
Last edited by atomicgale on Thu Feb 01, 2018 1:17 pm, edited 1 time in total.
Re: A Difficult Lesson in Simple Gun Safety
Hmm, doesn't your constitution have this 1st Amendment?atomicgale wrote:Actually, we're building a wall around Tennessee to keep the Liberals out.!
Seriously, you don't need a wall, the attitude is enough.
- SlartyBartFast
- Posts: 579
- Joined: Fri Jun 10, 2016 11:04 am
- Location: Montreal, Québec, Canada
Re: A Difficult Lesson in Simple Gun Safety
I'm surprised this forum doesn't enforce a no politics policy.atomicgale wrote:...
Have to say, that you're not doing Pilk guns any favors by associating them with your anger and bigorty.
To keep on-topic, unlike some, I'll tell this safety horror:
A previous supervisor was a military firearms trainer. He recounted a time when he was training recruits on pistol firing.
One recruit approached him, pointed a pistol at him and proceeded to pull the trigger multiple times while saying the pistol wasn't working.
The other officers on duty tackled the idiot and did serious damage to the idiots hand ripping the pistol out of his grip.
The idiot was ignoring his orders to point the pistol downrange as he approached and once it was pointed at him he said he just froze in disbelief.
- Smith & Wesson SW22 Victory
- FAS SP607
- FAS SP607