I have an Anschutz 1827B that is in need of a barrel. I would like to have the action threaded as opposed to the factory pressed and pinned method, just for ease of barrel changes if I ever decide to have more than one barrel configuration. I also have a 1907 stock that needs to be inlet for the 1827B action (magazine assembly) and pillar bedded.
The rifle will be shot scoped and also with sights. When shooting with a scope Ill be shooting off a bipod so accuracy will need to be #1 priority. I have emailed Chad Dixon @ LRI a few times but have not heard back, I know he is busy. I was thinking about giving Dan Killough a call to see if he was interested in taking on the project as his gunsmith Dan (I am not sure of Dan's last name) built a very accurate Stiller 2500XR for me.
I appreciate any experience you guys may have. Thank you!
gunsmith needed for Anschutz 18XX barrel change
Moderators: pilkguns, Marcus, m1963, David Levene, Spencer
Re: gunsmith needed for Anschutz 18XX barrel change
Joe Hein...
EliteShootingSport.com
hes Anschutz factory trained and a competitive shooter...
send him and email...
EliteShootingSport.com
hes Anschutz factory trained and a competitive shooter...
send him and email...
Re: gunsmith needed for Anschutz 18XX barrel change
I will thank you!
Re: gunsmith needed for Anschutz 18XX barrel change
I had Mark Penrod do the exact thing for my daughter's 54 action.
https://www.facebook.com/pages/Penrod-P ... 4369811267
https://www.facebook.com/pages/Penrod-P ... 4369811267
-
Thedrifter
- Posts: 280
- Joined: Thu May 05, 2011 8:26 am
- Location: San Antonio, TX
Re: gunsmith needed for Anschutz 18XX barrel change
I have been extremely satisfied with Chesebro, (Previously MT Guns).
http://www.chesebrorifles.com/
I have three rifles and I have shot a couple 599's on A50 Metric (Scoped) and 399's plus several 1600 & 1200's on the conventional target. plus the amazing work on my center fire guns. I am actually having a barrel repaired, a take off from another gunsmith that would not back their work and gave sub par workmanship.
http://www.chesebrorifles.com/
I have three rifles and I have shot a couple 599's on A50 Metric (Scoped) and 399's plus several 1600 & 1200's on the conventional target. plus the amazing work on my center fire guns. I am actually having a barrel repaired, a take off from another gunsmith that would not back their work and gave sub par workmanship.
-
1813benny
- Posts: 330
- Joined: Mon Mar 22, 2004 6:03 pm
- Location: state of total consciousness
- Contact:
Re: gunsmith needed for Anschutz 18XX barrel change
Threading the action is one option, with the other being a line to line fit with LocTite. This is a very common option vs threading.jbell wrote:I have an Anschutz 1827B that is in need of a barrel. I would like to have the action threaded as opposed to the factory pressed and pinned method, just for ease of barrel changes if I ever decide to have more than one barrel configuration. I also have a 1907 stock that needs to be inlet for the 1827B action (magazine assembly) and pillar bedded.
Regards,
ken