Need Help with Walther LP300XT

If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true

Moderators: pilkguns, m1963, David Levene, Spencer, Richard H

Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Post Reply
pardoctor
Posts: 38
Joined: Thu Nov 21, 2013 9:16 pm
Location: Central Florida

Need Help with Walther LP300XT

Post by pardoctor »

While at the 10m range last Friday I noticed that the trigger blade on the pistol was very loose and off center. I proceeded to reposition the trigger and use the correct allen wrench to tighten the screw (identified in the manual as screw "a"). I made no other adjustments and touched no other screws. And, much to my surprise the pistol would no longer fire. It will cock, but the trigger will not release. It appears to be frozen with no play front to back. Any help would be greatly appreciated!

Thanks,

Vince
Often wrong, but never in doubt!
Marc Orvin
Posts: 355
Joined: Sat Aug 28, 2004 12:23 am
Location: Colorado

Re: Need Help with Walther LP300XT

Post by Marc Orvin »

You may have put the blade too far back for it to release the sear. Move it forward a bit.
Post Reply