Anschutz 19/2013 Dovetails

HWN1011 · Post by **HWN1011** » Fri Jun 20, 2014 11:07 am

Does anyone have dimensions for the foresight dovetail grooves on an Anschutz 1913/2013? Also need the distance from the centre of the barrel?

Henry

justadude · Post by **justadude** » Fri Jun 20, 2014 10:40 pm

About 2/3 of the way down on this link Eric U has a pretty good explanation.

Distance from the center? Of the dovetail or the front sight aperture?

http://www.targettalk.org/viewtopic.php ... ail#171369

'Dude

HWN1011 · Post by **HWN1011** » Sat Jun 21, 2014 6:16 am

justadude wrote:About 2/3 of the way down on this link Eric U has a pretty good explanation.

Distance from the center? Of the dovetail or the front sight aperture?

http://www.targettalk.org/viewtopic.php ... ail#171369

'Dude

Thanks for the reply. The problem I was having was no access to anyone with a Anschutz 19/2013 I could measure. I am an engineer so already have the measuring pins. Luckily some one in my club has just purchased a 2013 so I will have a measure of his rifle next time I see him at the range.
I will post the drawing on here when it's done for anyone wanting it in the future.

Shifty · Post by **Shifty** » Sat Jun 21, 2014 4:06 pm

I have a 1913 you could measure mine on Tuesday!

HWN1011 · Post by **HWN1011** » Sat Jun 21, 2014 5:45 pm

Shifty wrote:I have a 1913 you could measure mine on Tuesday!

Thanks Lee
I will take you up on that offer. Didn't realise your rifle was a 1913.
Henry

Shifty · Post by **Shifty** » Sat Jun 21, 2014 6:49 pm

It's a 1913 in a 1914 stock - as I'm small the 1914 stock suited me better but as I only shot prone I went with the heavier 1913 barreled action! Dare I ask what you're planning?

HWN1011 · Post by **HWN1011** » Sun Jun 22, 2014 9:10 am

Shifty wrote:It's a 1913 in a 1914 stock - as I'm small the 1914 stock suited me better but as I only shot prone I went with the heavier 1913 barreled action! Dare I ask what you're planning?

Made some extension tubes. Want to make sure the grooves are machined in correct place to suit 20/1913 foresight.

HWN1011 · Post by **HWN1011** » Wed Jun 25, 2014 6:40 am

1913 Dovetail details attached for anyone that might need them in the future.

Thanks Lee (Shifty) for letting me measure your rifle.