Air Pistol valve seal material? Where to buy?

If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true

Moderators: pilkguns, m1963, David Levene, Spencer, Richard H

Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Post Reply
plink182
Posts: 44
Joined: Mon Aug 30, 2010 11:45 am

Air Pistol valve seal material? Where to buy?

Post by plink182 »

I am trying to find a source of a valve seal for a homemade valve I am working on, what material is used. I have seen what looks like nylon washers but are softer. What materials are typically used? Where can sheets or a variety of sizes of this flat material be obtained?
Top
Gwhite
Posts: 3445
Joined: Sat Sep 04, 2004 6:04 pm
Location: Massachusetts

Post by Gwhite »

I've made replacement Tau-7 (CO2) seals from scratch using nylon 6,6. Many pistols use O-rings, although I don't know that they use them for the firing seals. There are quite a few O-ring materials, ranging from teflon to soft buna-N nitrile.
Top
Post Reply

Return to “Olympic Pistol”