Need manual for my MG5

If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true

Moderators: pilkguns, m1963, David Levene, Spencer, Richard H

Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Post Reply
Reinhamre
Posts: 455
Joined: Thu Jul 01, 2004 10:17 am

Need manual for my MG5

Post by Reinhamre »

Can anyone help me with at least a spare part list?
My rear sight has lost "something", it may have fallen out.
It is not possible to rise the sight up anymore, it stays at its lowest.

What is connected to screw 5067 and makes the sight to rise?
User avatar
Jack Milchanowski
Posts: 206
Joined: Sun Jul 06, 2008 6:35 am
Location: In the woods of Sunset, Texas, U.S.
Contact:

MG5

Post by Jack Milchanowski »

Reinhamre
It appears to be a spring.
Attachments
MG5Parts.pdf
(422.27 KiB) Downloaded 149 times
Reinhamre
Posts: 455
Joined: Thu Jul 01, 2004 10:17 am

Post by Reinhamre »

Thank you!
What part number are you thinking of?

Does 5071 have anything that goes down and rest against screw 5067?
I can not find any other part.
User avatar
Jack Milchanowski
Posts: 206
Joined: Sun Jul 06, 2008 6:35 am
Location: In the woods of Sunset, Texas, U.S.
Contact:

Post by Jack Milchanowski »

Looking at the diagram part number 5067 goes into a spring (part no 5066). Part 5068 is the outer most knob which can be turned by hand or flat screwdriver.

Part no 5071 has a pin part no 5060 through the pistol frame which allows the entire sight assembly to move up and down. A screw #5070 attaches the adjustable sight assembly to 5071.

Jack
Reinhamre
Posts: 455
Joined: Thu Jul 01, 2004 10:17 am

Post by Reinhamre »

And what causes the sight to move upwards?
I will take photo tomorrow.
Do you have a MG5?
Reinhamre
Posts: 455
Joined: Thu Jul 01, 2004 10:17 am

Post by Reinhamre »

Something must go down in the hole mg5b and make the scratch seen on mg5a and make the rear sight move upwards as the sliding screw is moving right/left

Image

Image
Reinhamre
Posts: 455
Joined: Thu Jul 01, 2004 10:17 am

Post by Reinhamre »

It appears to be a 3 mm round ball that just drops down in the hole :-( When sight is on top pos. and you accidently lift the rear sight this ball can just fall out and get lost. Best to have a few spare balls around....
Post Reply