walther cp3 o-rings neede

[gfrad]

does anyone know the correct measurements for replacement seals for wp3 co2 pistol i believe the measurements are O-Ring ø14,0x3mm ,O-Ring ø6,0x2 ,O-Ring ø15,0x2 ,O-Ring ø4,0x1 ,O-Ring ø9,0x1,5
but I also need Inner Diameter:
and Width:

[Raymac]

Valve seal..........PN 249 00 21........6.0 X 2...green
Bolt seal.................247 23 09........4.0 X 1...black
Barrel seal..............247 22 95........9.0 X 1.5...black
Cylinder seal...........245 98 17......14.0 X 3...green
Cylinder fitting.........247 62 66......15.0 X 2...black
Two of the o-rings must be the green material that is compatible with CO2....black will not do. The inner diameter can be calculated if you need to.

[gfrad]

would you know were I can buy them from also an o-ring company i contacted is asking for width along with inner diameter

[Raymac]

Order from Earl's Repair using the Walther part numbers
http://www.carlwalther.com/

[gfrad]

at $5.00 an oring thats expensive anywere else from oring storethat i can find for better price

[headwizard]

Most specialty companies have a minimum order amount. The difference in that amount and the $30 you'll spend for the CORRECT o-rings will probably be negligible.