Trigger Shoes

Taylor · Post by **Taylor** » Fri Apr 15, 2011 5:40 am

Does anyone know if this trigger shoe commonly fitted to Feinwerkbau rifles and pistols

.. can be replaced with this trigger shoe commonly fitted to Anschutz rifles?

tsokasn · Post by **tsokasn** » Fri Apr 15, 2011 6:48 am

Yes,it can bee replaced(I've done it)
BUT
The hole in the FWB is slightly bigger than the ANS.
So,don't try to tighten the screw in order to get a tight fit.
Place a small and thin piece of metal to fill up the space.(preferably alluminium from a soda can or a fired .22 case)

Taylor · Post by **Taylor** » Fri Apr 15, 2011 8:24 am

Thanks, I want to fit the Anschutz trigger shoe to a Feinwerkbau air rifle.

If the clamping hole in the FWB trigger shoe is slightly bigger than the hole in the Anschutz trigger shoe then I would need to make the hole in the Anschutz trigger shoe slightly bigger to fit the FWB rifle.

I think this is correct from your explanation.

tsokasn · Post by **tsokasn** » Fri Apr 15, 2011 8:44 am

Exactly my friend!
In your case, you must enlarge the ANS hole.
Try some sand papre rolled cylindrical and "sand" the hole till it fits nicely.
Glad I could help!

Taylor · Post by **Taylor** » Fri Apr 15, 2011 9:01 am

Thanks mate :)

coolcruiser · Post by **coolcruiser** » Sat Apr 16, 2011 5:29 am

saaay...that's exactly what I wanted to do. Actually, I tried it out already but I had a problem. My FWB2602 has a dual rail for mounting the trigger. When I mounted the AHG trigger it was offset too much on either rail for me to get a good trigger contact. I ended up installing the AHG button on the FWB trigger stem. $10 from Neal Stepp....part #9715