Foresight Width

If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true

Moderators: pilkguns, m1963, David Levene, Spencer, Richard H

Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Steve Swartz
Posts: 444
Joined: Thu May 22, 2008 8:06 am
Location: Auburn, AL

Post by Steve Swartz »

Ahh yes certainly. The calculations should only be a starting point. How you actually perceive the sights/target is the important part.

I think I am a 5mm/4mm guy; sub six hold and equal amount of light sides and top.

"Your Mileage Will Vary!"

Steve
David M
Posts: 1685
Joined: Wed Mar 24, 2004 6:43 pm

Post by David M »

Its a trial and error test to get it right. I do not know the exact reasons but focal length, target defocus, sight radius and light level/angle all seem to play a part. (As well as the age of the eyes.)
Chris
Posts: 381
Joined: Fri Mar 12, 2004 11:03 pm
Location: OR

Post by Chris »

I did all of the calcs Steve went over. I did it with my FP, AP, .45, and .22. I was looking at all of them to see what the difference was. For some reason for me the 3.9mm front sight I had seemed appear very thin. When I put in a 4.8mm in I could see it better and found it was easier to focus on. Another positive was it is not crooked like the 3.9mm sight I had. I have a Toz35m so that should make sense.
Post Reply