TargetTalk

The ejector on my CM22 failed only once and it was due to my fault. Found out that if magazine is pushed all the way up the top of the magazine will contact the ejector. Mine is an early model SN 890 on latest models have not observed this type of mechanical interference. To avoid this I just glued ...

Check the micro switch on top of the trigger module and make sure is in pushed position when trigger is at rest. Switch should move to the extended position only when the trigger is pulled. I have seen this type of failure before and typical cause for this are either 2nd stage spring fatigue or trig...

Just for fun and reference here's how a right hand module looks like inside.

As Fabian mentioned on a previous post we have been able to bring to life several modules in the past years. A simple troubleshooting routine to pinpoint were the problems is originating is as follows: 1. Remove Printed circuit Assembly (module) from gun and flip the switch to on position: a: LED Bl...

Attached are a few pics of how I arranged all the shooting gear in a 1560. Basically I did a two levels arrangement, lower for the guns except the .45 upper for all other gears and the .45. The lower four pistols for all five of the ISSF pistol disciplines (Morini, Morini, Morini, Walther)? Yes, IS...

For the top portion I just sliced the original foam using a hot wire and glued a piece of D-Board or plastic signs material between the foam halves then added two cord string as pull handles. This setup has been used since 2008, travelling across US and several foreign countries and have endured man...

Attached are a few pics of how I arranged all the shooting gear in a 1560. Basically I did a two levels arrangement, lower for the guns except the .45 upper for all other gears and the .45.