TargetTalk

I think it has a 6 1/2 inch barrel so no go for ISSF. Would be OK for NRA

Thanks for the recommend re N320.. I have a bunch of it and have just acquired a new pardini .32 to go along with my .22. In process of getting bullets and brass. Will be using both Hertinberger and lapua. Is that 1.7 grains of N320 at 725 fps considered a slightly hot target load compared to say 1....

Just curious how many rounds of standard velocity target ammo can go down a well maintained target gun, before the gun would lose accuracy or become"shot out" if there is such a thing. An avid target shooter-competitor would put a massive amount of rounds out I would think. Do factoru supp...

I keep reading about replacing these but excuse my ignorance, where are they located and how do you replace them. I own FAS 602 and 607 which require buffers but they are easy to see and replace when you take the slide cover off, takes about two minutes to do. I would like to secure these buffers so...

I'm pretty sure my owners manual on my SP new states do not oil the trigger mechanism. I think oiling will attract contaminents, dust, powder residue etc.

Just purchased 1000 new .32 Hertenberger brass cases. Has anyone had any big issues using dillon press and dies to load wadcutters. I've never used these before, always Lapua or winchester. Just wondering if the wall dimensions are the same as other brass or are they going to be tight in the dies. A...

I am looking at purchasing a Britarms 2000. It belonged to a member of our club who sadly passed away over Christmas. Mike was a great guy, who I think owned one of every significant target gun made since 1960. He had a little fired Britarms which I like the feel of, similar to my FAS and 208 for po...

have a line on a case of .32 federal match 98 gr wadcutters, any com,ments on the brass as once they are fired will use that brass?

Hey I dont knoiw what all the griping is about re the IZH or AIRGUNS OF Arizona. I dont know the fellow there but congratulations for taking the initiative to acquire this fine and in demand air gun. Good luck hope you sell a ton of them. As to you guys who are putting up the negatives I say what gi...

Thank you to all who responded to my querry. Very kind of you and appreciated. Shooters are the best.

Rob

thanks for the reply Tony, apprecuate the input, did you contact FAS on the internet regrads parts?

Regards

Rob

Looking at purchasing a FAS SP602. Anyone have any feedback on these pistols. This one is lightly used and is the FAS model not the FAS-DOMINO.The mags load from the top. Any issues with function on these. What ammo feeds well. I usualyy have eley pistol target(yellow box) CCI std and fiocchi on han...

Earls repair in Ma. has parts for walthers. Was just emailing him and he gets them from Walther in Germany. You should think about getting the usual spares ie firing pin , extractor and main spring. The guns post 1975 had no issues, the older ones could have frame cracking. Dont use high velocity am...

Any recommendations on lubing a new pistol. What method to clean bore, is CLP OK for bore and crossman pell oil for seals?