TargetTalk

If I recall correctly, it is M5x0.8

Sending a PM with some information.

I will see if I have something to ship them in.
It will be more efficient to use direct contact, I will send it by PM.

How many are you looking for and where are you located?

Hello,
I just sent you a private message regarding this.

Pete

Most of the commonly available rear sights, other than for Feinwerkbau, will work. The front sight dovetail is Walther specific and only a Walther specific sight will fit.
I will send you a PM with details on some things that I have available.

I don’t know which manufacturer they use but the diameter used is listed on the test target card included with the gun.

Sounds like it should work, try additional light directly on the target, I use a 500watt led work light positioned about 3feet from and aimed directly on the target.
Even though I have good general lighting, I get similar results if I don’t have the work light on.

In addition to the operating software, have you also downloaded the drivers from the Scatt website?
Also, the trigger sensitivity setting is counter intuitive, reducing the percentage increases the sensitivity.

What are you using for the aiming point?
What do you have for lighting on the aiming point?
Do you see the target in preview mode and if yes, how does it look?

A better description of the environment than you are operating in would be helpful to know. Assuming that both units are IR based, not camera type, any reflective surfaces such as polished floor between the sensor and target? What type of heating system, forced hot air/ typical range ventilation? Mi...

If you don't find the fixed aperture that you are looking for, Centra has available a Glass iris with a 1.2mm wide aperture ring. www.centra-visier.de/en/products/sights/front-ring-sight/adjustable-front-sigts-rings/iris-glass-font-sight-ring-12/ I have this iris in the 3.8-4.8mm size in stock, plea...

Michael, The “grooved barrel” dovetail generally will not fit correctly on the dovetails that are either machined into or screwed onto the common American barrel band type front sight mount. In the Centra product line, the fitment designation that you should choose is “match 54”. This will have a ba...

Sent you a PM with some information.

In recent years Capapie has almost become the only thing that top shooters wear. What makes their products preferred over traditional brands like KT and Sauer? The same thing that has historically led to this, some manufacturer introduces something that gives an advantage in performance and everyon...

Yes, Centra still makes the 10-50 rear sight.

Pete

You use the distance from the sensor to the target.

I recently did this though from a shop in Germany. It was not inexpensive. At the time, 2 shops in the UK had the rifle but both said that they needed a license that they did not have so could not do it. You will need to have a US based Importer bring it into the US. I will PM you the one that I used.

The best resource on this is found in the ISSF General Technical Rules, section 6.4.14. /www.issf-sports.org/getfile.aspx?mod=docf&pane=1&inst=458&file=1.%20ISSF%20General%20Technical%20Rules.pdf In short, the required minimum lighting level for the general range area/firing line is 500 ...

If you are looking for something similar to the charts that are common in hipower that tell you how much a given flag condition/wind speed will move the bullet, I don't think I have seen that. Smallbore wind charts are pretty generic, just giving you the direction that a wind flag condition will mov...