TargetTalk

Well,we don't have a qualified FWB dealer/service here so I guess I must pack and send it to mother FWB...
Strange thing is that with a cylinder charged at 175 bars,I don't face that behaviour...

So... I changed the firing pin spring(have run more than 1000 pellets),I changed the air cylinder,I treat the rifle with a lot of looove,but today I felt like I wanted to throw it in the target range... As I was practicing,at about the 50th pellet,it lost velocity... POI was at 8,six o' clock... Uns...

Good morning Peter!
Believe me,it has a lot!!!

What's TLC?

Update. Came back from practice. Yesterday,I set the velocity at A.S. 570f/s. Today,before pracrice I measured it at 450 f/s... I unscrewed and screwed the air cylinder and velocity rised... Done the same again,and the velocity falled... Then I tryed another air cylinder,from a 700 model. With that ...

Hello again my friends. I would like to continue here my new problem rather than open a new topic. So August was a vacation month in shooting for my rifle. When I got back in September.,my rifle started to loose velocity. 3 shots POI in the 10 ring and then the rest fell off the target,six o'clock.....

Nut-fore end-spacer-old palm rest with the opening along the rest and square head bolt that slides,secures for tighteng on that opening and holds everything together.
Gives the opportunity to play further with the center of gravity;

Good morning Peter.
I am in the range and just finished crony.
AS after cleaning is 583 f/s.
Is it too much?
Should I back off a bit?
This speed is with the spring being fully compressed by it' adjusting screw

What is the speed that I should go for ?

So,today, I managed to crony the rifle... Average speed was 525f/s... I then took off the hammer block and degreased it... Yes,that is correct my friends,I degreased it... And that's because in a previous maintenance interval,I greased the hammer pin because I thought it was correct... Any way,got t...

Will do!!!
Thank you!!!

Good morning!
I have already tightened the spring to it's limit.
I will check it tomorrow if it has came loose.
If it hasn't,then a new spring will be ordered

Hello folks! I've been notified about low velocity on my FWB P70. I can hear it,and so do other athletes. The point is that I once tryed to raise the velocity by tightening the screw of the "firing pin's" spring and it had reach the max tightening position,with the velocity,measured with s...

Good morning from sunny Greece!
So,any extented weights to the back (you know,the classic rod projecting backwards) is prohibited?
Something else,weights on the rear side of the buttplate,facing and projecting forwards are allowed?
Thank you!

Hello my friends!
I'been looking the new rules regarding adding weights on the cheek piece.
I didn't find anything but I may be missing something here...
Are weights allowed to be attached on the cheek piece and if yes,where?
Thank you!

I like it!
Will try it too!

Nice input!!!
Thank you!

I was wondering for Nazar.
I did not see him in Rio or Bologna...
Anyone knows why he is not shooting?

I too also had BBs in mind but they were pretty expensive for the quantity I need to fill the roll...
By the way,I think that plain cork that I use is guilty for being compressed after some time of seating that gives me sideways move?

Must find a solution here...

Hello my friends!
Sorry for my delayed reply and thank you for your inputs!

Everything saws that I must work harder with the mental game...

Once again,thank you.