Page 1 of 1
Storage of PCP guns
Posted: Mon Aug 16, 2004 7:09 pm
by RobH
Is it recomended to unscrew the air cylinder of an air rifle (or pistol) when not in use for a day? How about a week?
Thanks
Rob
Posted: Mon Aug 16, 2004 7:51 pm
by pilkguns
for day, probably not, for a week yes, be sure and unscrew the cylinder all the way, don't go halfway out and then start back in, you can pinch the o-ring
Removing cylinder
Posted: Mon Aug 16, 2004 9:54 pm
by Mike Taylor
OK, that's from the horse's mouth, and for that reason alone I'll do it; but my mechanical curiosity is aroused. What's the downside of leaving the cylinder on the gun for a prolonged period?
Mike T.
Posted: Tue Aug 17, 2004 2:08 am
by RobStubbs
I leave my cylinders on the guns permanently as I feel constant unscrewing will risk damaging either the thread or more likely the O-ring. Admitedly mine are generally fired generally every 2-3 days but even on longer rests they are still left in place.
Rob.
Posted: Tue Aug 17, 2004 7:23 am
by pilkguns
the problem with leaving it on all the time is the that you keep the regulator pressurized, which is bad for the springs and worse for the o orings, meaning that they will have to be replaced sooner rather than later.
Just what that schedule is though, has too many variables to reliably predict. If you maintaina light amount of the proper grease on the threads as instucted in your owners manaul, then you should'nt have to worry about thread wear
Storage of PCP guns
Posted: Tue Aug 17, 2004 12:07 pm
by eugenegazda
What about CO2 guns?
Posted: Tue Aug 17, 2004 7:06 pm
by Guest
I have a Morini 162e (non removable cylinder) - any thoughts as to whether I should release the pressure if i'm not planning on using it for a couple of weeks?
Posted: Thu Aug 19, 2004 6:27 pm
by pilkguns
CO2 guns do not have any where near the same pressure, nor do they have a regulator, so they are not as punishing on springs and o-rings as CA guns.
regarding the early Morini, thats a tough call.... For sure I would not fill it up at the end of a shooting sesssion, wait until I was going to shoot it again before re-filling. If I was not going to shoot for some longer lenght of time.. 2 weeks or more maybe? then I would drain the cylinder
Posted: Fri Aug 20, 2004 7:00 pm
by Jerry LeVan
At one time I had a Morini, I left a filled cylinder on for a little bit
longer than a month...When I went back to the Morini, I found the
cylinder empty.
I suspect a leak through a regulator is quite possible, normally
one would not need long time retention in the regulator system
for an AP...
Jerry
Posted: Mon Sep 13, 2004 10:20 am
by Kennyshoots
Hello all,
Just a small input of my experience...I have a Steyr LP1 I purchased new in 1995. It has been pressurized since the day I got it! It has seen periods of storage of over a year with no ill effects that I have noticed. (It has never leaked down!) I am now actively shooting it again and it is shooting as it always has, GREAT!
Just thought I would share this.
Kenny