TargetTalk

I have an LP2 that is 10 years old and used fairly frequently, I have noticed an unusual anomaly with the trigger function . If I hold the pistol in a
shooting grip while sitting comfortably to view the trigger and trigger finger , while it is in dry fire mode . When the trigger is pulled/pressed the
trigger will suddenly snap forward when the sear has released the shot. It is quite a noticeable movement , but enough to interrupt the smooth trigger release and follow through which at that point is not possible . So, while dry firing and live firing ,the trigger will at time of break , will jump forward and then immediately backward then continuing on to the rearward follow through process . The trigger weight is set at 500 grams , the trigger stop is set with a generous clearance setting.

Is this normal with all the LP2 and or all Steyrs ? Or is it a faulty trigger .......

I haven't had this problem on my Steyr, but vaguely remember it with my Hämmerli. As I recall, I added just a slight bit more of sear engagement to fix it. That's the screw that is painted red, aka the "don't adjust" screw.
Did it start all of a sudden, or over time?

sold a FWB 65 springer for new LP2 10 yrs ago , for me it was a big improvement from the springer. But there was always the called center shot that
was way off center , recently wifey said I should be dry firing to fix the long shots . So, i did that and found out a few errors of my ways to get a better shot . One was to sit in a chair and just look at the sights and dry fire and just looking at the trigger pull etc . Then one day I was working hard at my follow through and voila , my follow through was interrupted by this trigger going in the wrong direction on a very controlled trigger action.
my technique is a slower smooth pull concentrating on follow through , No possibility of a follow through with this trigger setup. This anomaly is really bothering me and I believe it is a cause of some poor shots . I will try the sear setting , giving it more engagement sounds like a good idea , adding a little creep doesn't bother me .

If I recall correctly, and it's been a while, once I gave the sear a little more engagement, I had to back off the trigger weight screws. It's as if I had the weight screws set up to compensate for the fact the sear was on the edge, and once it broke, the trigger kicked back. It didn't take much more engagement to fix the problem, I mean just a smidge counter clockwise from where it is now. Your overtravel will probably need an adjustment afterwards.

Sideoiler as in Ford?

I'll do a little tinkering on it tonite .

yep , 427 big block

If you get too far into the weeds for some reason, the below setup by David M is spot on IMO.






https://www.targettalk.org/viewtopic.php?f=4&t=60674

Thanks you for the adjustments link and thanks for the tips . I did the quick and dirty adjustment by the seat of my butt . Backing off the said screw
fixed the rebound in the trigger , and no more hesitation in the smoothy of the trigger travel . Getting the follow through is cake now . I had to reset the trigger weight, it went quite high but was able to get it back to 500 gm .

Thank you so much for your help and the link .

You are most welcome. Go shoot tens.

The trigger is probably not damaged. It needs to be thoroughly cleaned and completely reset. The complete setup has been addressed here before by the David M's detailed instructions. See link above