Page 1 of 1
10 meter targets to fit a GAMO holder?
Posted: Thu Jul 02, 2020 11:31 pm
by McMadCow
This is probably an odd one, but does anyone sell ISSF 10 meter air pistol targets in the 5x5 form factor that the Gamo target traps use? I have my target trap set up for those and I've been using the Gamo branded targets which are close-but-not-actually ISSF 10 meter targets. I could probably rearrange my setup a bit to accommodate the 7x8 sheets they usually are printed on, but I'd prefer to stick with how I already run things.
Any help is appreciated!
Re: 10 meter targets to fit a GAMO holder?
Posted: Fri Jul 03, 2020 1:44 am
by David Levene
If you try to print an ISSF air pistol target on a 5 x 5 inch card then you would lose parts of the 1 & 2 rings.
Re: 10 meter targets to fit a GAMO holder?
Posted: Fri Jul 03, 2020 3:25 am
by McMadCow
David Levene wrote: ↑Fri Jul 03, 2020 1:44 am
If you try to print an ISSF air pistol target on a 5 x 5 inch card then you would lose parts of the 1 & 2 rings.
Oh geez, I didn't even think of that. Haha, oh well, I guess I'll just move my clips to accommodate the real target.
Re: 10 meter targets to fit a GAMO holder?
Posted: Fri Jul 03, 2020 7:17 am
by Rover
McMadCow wrote: ↑Fri Jul 03, 2020 3:25 am
David Levene wrote: ↑Fri Jul 03, 2020 1:44 am
If you try to print an ISSF air pistol target on a 5 x 5 inch card then you would lose parts of the 1 & 2 rings.
Oh geez, I didn't even think of that. Haha, oh well, I guess I'll just move my clips to accommodate the real target.
Who the hell shoots into the 1 & 2 rings anyway? But then, I guess they're there for a reason.