Pardini K2S Reseal ??
Posted: Fri Sep 20, 2019 2:42 am
Hi,
I am trying to reseal my K2S. I have a seal kit, parts diagram, etc.
I've taken care of the cylinders and the air reducer. Easy to do with a pin wrench.
I cannot figure out how to get to the "chambering sliding block". This assembly looks easy enough to disassemble by removing the drift pins. But how do you get it out? Removing the barrel looks like it's needed. But, that thing doesn't seem to want to budge. I've removed the barrel retaining screw, mounted the barrel in a padded bench vise, and applied as much effort as I would think needed to the receiver.
Anybody have any experience?
I am trying to reseal my K2S. I have a seal kit, parts diagram, etc.
I've taken care of the cylinders and the air reducer. Easy to do with a pin wrench.
I cannot figure out how to get to the "chambering sliding block". This assembly looks easy enough to disassemble by removing the drift pins. But how do you get it out? Removing the barrel looks like it's needed. But, that thing doesn't seem to want to budge. I've removed the barrel retaining screw, mounted the barrel in a padded bench vise, and applied as much effort as I would think needed to the receiver.
Anybody have any experience?