Page 1 of 1
Need Part(s) for FP10 URGENTLY
Posted: Tue Jun 11, 2019 2:37 pm
by MGFP10
Hello All: The base of the rear sight of my FP10 Hammerli freepistol is bent after a fall. I am fine but my FP10 needs a replacement part. Here in Australia it is very difficult to find parts. Has anyone a schematic parts drawing so I may identify the needed part? Has anyone contacts for parts supplies? [NOTE: the base for the rear sight assembly attachment, about 1cm wide and 4cm long, black coloured with grey/silver standard engraving (NOT the rear sight itself) is bent and attached with two (2) bolts to the red coloured aluminum frame.]
Please help. Kindly, Michael
Re: Need Part(s) for FP10 URGENTLY
Posted: Tue Jun 11, 2019 7:59 pm
by dino911
do you have a photo of the part needed ?
Re: Need Part(s) for FP10 URGENTLY
Posted: Wed Jun 12, 2019 11:09 am
by scerir
Re: Need Part(s) for FP10 URGENTLY
Posted: Wed Jun 12, 2019 1:22 pm
by Gwhite
Hard to tell from the description & the drawing, but it sounds like you need part #1066.
That's probably going to have to come from the factory. It's certainly not a part that would be commonly replaced and kept around as a spare by a dealer/gunsmith.
Re: Need Part(s) for FP10 URGENTLY
Posted: Thu Jun 13, 2019 1:20 am
by Leon
Have you contacted Frontier Arms to see if they have that part in stock? If you have, and they haven't, when I get home I'll post details of a German dealer who will help you out with awesome Teutonic speed and efficiency.
I have used them in the past and they rock...
Re: Need Part(s) for FP10 URGENTLY
Posted: Thu Jun 13, 2019 5:06 am
by Leon
Leon wrote: ↑Thu Jun 13, 2019 1:20 am
Have you contacted Frontier Arms to see if they have that part in stock? If you have, and they haven't, when I get home I'll post details of a German dealer who will help you out with awesome Teutonic speed and efficiency.
I have used them in the past and they rock...
Try
https://www.schiesssport-buinger.de/shooting/Home
The same part from a FP500 is probably identical to the same on an FP10.