TargetTalk

For the life of me I can't figure this out. I have a walther lg55 Tyrolean with the barrel shroud attached, and when I shoot off hand it hits consistently low. Although when I shoot it rested it hits high. I have the sight adjusted all the way up, but every time I shoot it off hand it hits about 1/4 inch low at 10m. I have a fwb 300s, diana 75u, diana 100, and a walther lgr, none of them shoot low like this. Since it shoots a bit high rested with my sight adjustments, I assume its something in the way I shoot this gun off hand but I have no idea what. I've taken to just aiming high but its an inexact science I would prefer to avoid. If anyone has any suggestions I would greatly appreciate it.

Could the spring and piston be recoiling differently between a rest and an off-hand hold?

I doubt that your eye position is tbe same. A slight position change in the rear sight location(eyeball Center) is almost gauranteed to have occured..

Tim S wrote:Could the spring and piston be recoiling differently between a rest and an off-hand hold?

Yes.

POI will always vary offhand vs rested with a springer. Thats normal.
All other rifles you have, are non-breakbarrels.
Id check yr barrel lockup and breech seal.
Has it ever been serviced?
I had height issues with my LG55T too at first. Turned out the peep sight was bend (probably damaged during transport or once fallen onto the sight).

thanks everyone for the suggestions, they have been very helpful.