Page 1 of 1
rear sight removal
Posted: Thu May 10, 2018 9:26 am
by tonyd123
I have a walter gsp and I want to switch over to a dot. I have champions choice base . there are 2 pins to remove, but i only see one side of pins. So how do I remove pins.
Re: rear sight removal
Posted: Fri May 11, 2018 5:57 pm
by Rover
Since no one is tossing out words of wisdom, I will suggest Mother's Sovereign Remedy:
Get a big hammer. I'm sure William would lend you one.
Re: rear sight removal
Posted: Sat May 12, 2018 1:42 am
by SamEEE
This might help, just take it easy though.
https://en.wikipedia.org/wiki/Heavy_Press_Program
After removing/shearing-off your rear sight you could also turn some Titanium into F15 bulkheads. :-)
Re: rear sight removal
Posted: Sat May 12, 2018 2:53 am
by Lukas90
First, unscrew the two outer screws on the right side of the rear sight and take off the detent piece and the fitting piece.
Then, remove the remaining center screw. Lastly, drive out the two pins from the left side of the pistol and remove the rear sight assembly. Be careful not to lose the spring that sits between the bolt housing and the rear sight assembly.