Pistol canting to the left
Posted: Fri May 13, 2016 7:06 pm
While I have not shot formal competition since intercollegiate smallbore pistol in 1970-71 I have generally shot bullseye targets since. About 4 or 5 years ago I made the mistake of purchasing some steel targets - gongs, silhouettes etc. They are a WHOLE LOTTTA FUN but my precision skills have gone to crap. So I am back to paper.
I FINALLY after 35+ years installed a set of Herrett's Nationals grips on my Clark hardball gun. I noticed that I was canting the pistol to the left. I put this down to the nice thumb shelf and my lazy thumb napping on it. I have switched to a different pistol (1911 style with Pachmayr rubber grips.) I still notice that on occasion I am canting the pistol to the left although not so badly as with the Nationals.
I do not remember having this problem in the past. When shooting steel it did not really matter and perhaps the problem developed when I was having too much fun. I am making a conscious effort to correct the sight level with each shot. However, it would be better to not have to worry about this.
Can anyone recommend any exercises or drills to help holding the sights level without having to think about it?
TIA,
Ken
I FINALLY after 35+ years installed a set of Herrett's Nationals grips on my Clark hardball gun. I noticed that I was canting the pistol to the left. I put this down to the nice thumb shelf and my lazy thumb napping on it. I have switched to a different pistol (1911 style with Pachmayr rubber grips.) I still notice that on occasion I am canting the pistol to the left although not so badly as with the Nationals.
I do not remember having this problem in the past. When shooting steel it did not really matter and perhaps the problem developed when I was having too much fun. I am making a conscious effort to correct the sight level with each shot. However, it would be better to not have to worry about this.
Can anyone recommend any exercises or drills to help holding the sights level without having to think about it?
TIA,
Ken