Page 1 of 1
Izh-7-3 rising block (for the foresight)
Posted: Wed Apr 29, 2015 3:26 am
by conradin
Anyone has an idea how to put a rising block for the foresight of a 7-3? The 7-3 is slightly smaller than I want it to be. If I have to I can switch the rear sight to Anschutz with rising block, as Altius has a conversion block for the rear sight. But there is no such thing on the front....I cannot shave my cheek piece any further! :)
Re: Izh-7-3 rising block (for the foresight)
Posted: Wed Apr 29, 2015 9:46 am
by rodn
I didn't realize the 7-3 was that small. Thanks for the info.
Hope someone here knows.
You might want to post in the "Russian Rimfires & Biathlon" section of
www.rimfirecentral.com
Good luck
Rod
Re: Izh-7-3 rising block (for the foresight)
Posted: Thu May 07, 2015 9:51 pm
by conradin
Nobody knows how to raise the front sight of the Izh?
Re: Izh-7-3 rising block (for the foresight)
Posted: Fri May 08, 2015 2:38 pm
by Krenovian
If you have talked to Marc at Altius and he couldn't help I doubt there is an off the shelf solution other than a custom milled piece. The other sources to try would be Larsenbiathlon.com in Norway. You might also check with Nordicmarksman.com in Canada. However, neither website shows a riser for the Izmash foresight or a taller foresight that I can see.
CJ
Re: Izh-7-3 rising block (for the foresight)
Posted: Fri Oct 23, 2015 11:54 pm
by Levergun59
I'm not sure of the OD of the 7-3 or 4. The OD of the 7.2 barrel was .750. You can mount a small Anschutz bloop tube on the barrel if it is .750 and use the 11mm grooves to mount a sight riser and an Anschutz sight. I doubt the 7-3 and 4 barrel are that hefty but at least you can measure. You might be able to shim the barrel to attach the clamp.
Chris