TargetTalk

Hello everyone, I have a 162e need help.
morini 162e I have a air leak on the trigger (when we insert the cylinder to the gun) I think it was from O - ring worn on the image and I want to change it. Please tell me how to change it. O - ring where? And please show step by step procedure (I think I can do it if instructed).

Thanks in advance to all of you.

Not enough information, it could be a number of things, O rings or valve.
Please be more specific, how old is pistol, when last serviced, where is
leak, rate of leak etc.

Thank you for advice Adoptee
162e is unlikely to last more than 15 years, I have come from the original owner about 1 year. Can operate normally and has never been repaired. I use it to fire 4,000 rounds or more.
Last week, while I used it a regular practice to have 2 shots. When they shot 3 was found to have air leaking out of the gun (the wind out of the trigger guard) quickly takes about 2 minutes, the wind was out of air cylinder(150 bar). I tried switching to a new cylinder is the same. I think this is likely due to the O - ring wear. And I think I can fix it if instructed thoroughly. Because if I have to put a gun to find a mechanic means I have to travel far 400 miles, which would cost more than the gun and it should be the last option. (I think I can fix it, but I do not know the steps to remove it).

Thanks for the suggestions

Use a dental pick or needle nose pliers. It doesn't matter if you destroy it getting it off.

Time for a full service, lube and seal kit.
Also check and clean the valve (162047T).
If you have not worked Air pistols before
find a gunsmith who knows what they are
doing.

Thanks for the advice, David M
I think I will try to tear it out and see if it does not work, I have to take it to the gunsmith found.