Extra weights for LP-@ or LP10 w/ Ansch bar

[David W. Johnson]

I don't recall how I found these on Amazon, but they are shaft collars. I ordered a couple in 12mm ID. I was too lazy to go out to the garage and use my calipers to determine the diameter of the Anschutz weight bar, but it turns out I was right. They fit the bar just like the factory weight. They are a bit wider and the diameter is less. That just means they will not come as close to the cylinder. The factory weights cut it close.

I figured if anyone wanted additional weights, but couldn't find them for sale, this information would be useful. I weighed the factory weight at 24 grams and these at 23. Close enough for me.

If you want to add this type of weight bar to an LP10, it is available on ebay from a guy in Bulgaria. I've ordered from him before. He's legit. He appears to get his stuff from the factory auctions that I order some of my bits and bobs from. The extra bars are almost always available. The mount that goes on the trigger guard appears every once and again.

The one on the left is Anschutz. The other two cost me $1.80.

David